Viper Stripes Direct - Downloadable Application Instructions

To view the application instructions you will need the free adobe acrobat reader. Alternatively you can view them below.

Instructions for wet application of vinyl stripes:

Prepare the surface. Application surface must be clean of wax oil and grease.
Position striping as a test fit. Be careful not to stretch the vinyl.
Prepare a soapy solution using 4-5 drops of dish soap to one quart of water. Do not add too much soap as this will prevent proper adhesion. Position striping and remove release liner exposing adhesive.
Wet the back of the exposed striping and the application surface thoroughly. Press striping on to application surface removing some of the solution.
Position the stripes where you want them. Take a step back to eye up the alignment. Re-position as necessary using measurements from the reference points of the vehicle. (i.e. The cars logo or washer jets.)
Once properly aligned, go over the entire stripe with a soft cloth or squeegee to ensure bond and that no air bubbles are present.
Check your work the next day. If you find air bubbles, pierce them with a pin and gently work the air out with your squeegee.
To ensure a permanent bonding, allow at least 72 hours in direct sunlight before washing.

For more information please email us at enquiries@viperstripesdirect.co.uk